Beurer PM 58 Specifications Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 116
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
23
Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference
of 22 to 30 cm. A larger cuff for upper arm circumferences
from 30 to 42 cm is available from retailers or the service
address under order no. 163.246.
Correct posture
Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
You can perform the measurement either sitting or lying
down. Always make sure that the cuff is on a level with
your heart.
To carry out a blood pressure measurement, make sure
you are sitting comfortably with your arms and back lean-
ing on something. Do not cross your legs. Place your feet
flat on the ground.
In order not to distort the result, it is important to keep still
during the measurement and not talk.
Measuring blood pressure
Move the touch screen activation switch to the ON position.
Put on the cuff as described previously and assume the
position in which you want to carry out the measurement.
Switch on the blood pressure monitor with the START/
STOP button
. After the full-screen display, the most
recently used user memory appears ( or ). To change
the user memory, press the MEM button and confirm
your selection with the START/STOP button . If no but-
ton is pressed, the most recently used user memory is
automatically used after 5 seconds.
Before the measurement, the last saved test result is
briefly displayed. If there is no measurement in the mem-
ory, the instrument always displays the value .
The cuff automatically inflates. Cuff air pressure is
released slowly. If a tendency towards high blood pres-
sure is already detectable, the cuff is pumped up again
and cuff pressure increased further. As soon as a heart
rate is detected, the heart rate symbol
is displayed.
Heart rate, systolic and diastolic blood pressure are dis-
played.
You can cancel the measurement at any time by press-
ing the START/STOP button or by pushing the touch
screen activation button to OFF.
appears if it has not been possible to perform the
measurement properly. Observe the section in these
instructions on error messages/troubleshooting and
repeat the measurement.
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 115 116

Comments to this Manuals

No comments