Beurer LW 110 Service Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
13
4. Unit description
1. Fan button
2. On/off button
3. Air inlet
4. LCD display
5. Air outlet
6. Fill level sensor
7. Protective cap
8. Handle recess
9. Lock
10. Fan unit
11. Upper cover
12. Holder
13. Humidification discs
14. Tub
5. Initial use
Removing the transport lock
Open the cardboard packaging.
Keep the plastic film closed and remove the device upwards by lifting it out using the handle recesses on
the upper cover.
Now remove the plastic covering.
Check the device, mains plug and cable for damage.
Lift off the upper cover with the fan unit, lift out the humidification discs at the holder and remove the
transport lock. Check to ensure that you have removed 5 foam transport locks. (There may be an additional
foam transport lock in the fan unit. Turn the upper cover with the fan unit over to check it.)
Reinsert the humidification discs. The holder automatically falls to the side and must face the side of the
fill level sensor.
Filling with water
To fill the tub, lift out the upper cover with fan unit by the side handle recesses and place to one side.
During filling, leave the humidification discs in the tub. Fill the tub with fresh, cold tap water maximum up
to the lower edge of the “MAX” marking on the inside of the tub. The most straightforward way to do so
is to use a large container free of limescale and impurities (water can, jug). Use only fresh, cold tap water.
We suggest to fill in 5 liters to have the best humidification output.
2
4
3
5
1
10
13
14
12
11
7
6
9
8
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments