Beurer LW 110 User Manual download pdf (Page 15)

Graphic displayed Fill level

Residual water in tub.

The tank must be refilled.

Device automatically switches off after 6 hours.

The device has switched itself off due to safety reasons. Clean and refill the

device before next use.

The air washer is switched off by pressing the On/off button

on the upper side.

Regularly check the water level gauge during operation and refill the tub if necessary.

Note:

•

The actual humidification output depends on the ambient conditions and the air contact with the

humidification discs. In principle, the lower the relative air humidity, the higher the humidification,

and the greater the damp contact surface with the air, the higher the humidification.

•

The LCD illumination reduces 5 seconds after a button has been pressed. The reduced display

illumination enables the device to be operated in bedrooms.

•

Use fan level 1 to operate the device during the night.

7. Cleaning and storage

Regular cleaning is a prerequisite for hygienic and fault-free operation.

The air washer can be dismantled easily and without tools for cleaning.

Always empty and thoroughly clean the air washer if the device contains water and has not been operated

for longer than 3 days.

A lack of cleaning and hygiene can cause bacteria and fungi to form in the water.

Rinsing the tub

Rinse out the tub every 2 weeks with clean water. If the air is heavily polluted, the device is used intensively

or the water quality is poor, the air washer must be cleaned at shorter intervals. If necessary, remove any

deposits in the tub using a plastic brush.

Cleaning the fan unit

You can wipe the fan unit with a damp cloth. However, make sure that no liquid enters the fan unit.

Cleaning the upper cover

Remove the fan unit to more easily clean the upper cover. To do so,

slide the 4 locks to the outside and remove the fan unit.

Important: When putting the fan unit down, ensure that it does not

come to rest on the water level sensor.

Cleaning the humidification discs and tub

You can wipe the humidification discs and tub with a damp

cloth or clean them thoroughly and easily in the dishwasher.

Lift off the upper cover, remove the humidification discs

from the tub and place them in the dishwasher. Unlock

the water level sensor (Figure 1) and remove it (Figure 2). If

there is insufficient space in the dishwasher, create extra

space by removing the cutlery basket, for example. The

humidification discs and tub must not be bent or jammed

when being placed in the dishwasher.

Set the dishwasher to a gentle cycle (for cleaning glass) and if possible remove the part before the drying

process. The cycle must not exceed a temperature of 50 °C – otherwise the plastic parts may deform.

Only continue to use the device when the exterior of the tub is completely dry.

Figure 1

Figure 2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Comments to this Manuals

No comments

Beurer LW 110 User Manual Page 15

Comments to this Manuals