Beurer PM 58 Operations Instructions download pdf (Page 15)

Putting on the heart rate monitor

You can wear your heart rate monitor like a wrist watch. If you would

like to use the HR monitor when riding a bike, fix the monitor to the

handlebars. This improves the signal transmission greatly. Use the

assembly bracket supplied and fix the HR monitor firmly on to the

handlebars so that the monitor does not slip when riding the bike.

Initial activation of the heart rate monitor

You can activate your heart rate monitor from the transport mode by

pressing any button for 5 seconds.

Activating the heart rate monitor from power saving mode

If the heart rate monitor has not received any signal for approx. five

minutes, it switches to the power saving mode. At that point, only the

current time and the date will be displayed. Press any button in order

to reactivate the watch.

Putting on the chest strap

 Tighten the chest strap with the elastic tension belt.

Adjust the length of the belt such that the belt is

snug, but neither too loose nor too tight. Position

the belt around the chest such that the logo is fac-

ing outwards and in the correct position directly

over the breast bone. For men, the chest belt

should be located directly below the pectoral mus-

cles, for women, directly below the breast.

 Since optimal contact between the skin and the heart rate sensors

can not be created immediately, it may take some time until the

heart rate is measured and displayed. If necessary, alter the posi-

tion of the transmitter in order to achieve optimal contact. Most of

the time, sufficient contact is achieved through the accumulation

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 143 144

No comments

Beurer PM 58 Operations Instructions Page 15