Beurer PM90 Operations Instructions download pdf (Page 35)

Once you are in the menu

Training, your HR

monitor automatically switches to the main dis-

play. This displays the already recorded training

time on the middle line (after Save/Delete:

00:00:00) and on the line below

Start.

By pressing the

button you can change

the information in the bottom line.

Things to know about the recordings

 As soon as you have started the recording, your HR monitor

starts recording your training data. Your HR monitor continually

records your training data until you save or delete this. This also

applies when you first start training on the following day. The run-

ning time also allows you to stop your training session at any

time.

 If “0” is displayed for a longer period on the display, this means

that the receipt of the signals has been interrupted. In this case

change into the

Training menu, by pressing

8 times.

The HR monitor tries to make contact with the devices once more.

 Your HR watch has a memory. You can record up to 23:59:59

hours in each training session. Depending on the sampling rate,

you can record training periods ranging from 2.8 hours (with a

5 sec rate) to 67 hours (with a 120 sec rate). Once 23:59:59 hours

is reached, you must either save or delete the training session to

allow a new training session to start. Please note that the sam-

pling rate (5 sec / 30 sec / 60 sec / 120 sec) cannot be changed

during the recording!

A maximum of 50 laps is possible for each

training. Your HR watch informs you if the memory is almost full.

At this point, at the latest, we recommend transmitting the re-

cordings to your PC and thus emptying the memory on the HR

watch. Alternatively you can delete all recordings manually. Read

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 143 144

No comments

Beurer PM90 Operations Instructions Page 35