Beurer PM 62 Operations Instructions download pdf (Page 12)

Activating the heart rate monitor from power saving mode

You can activate your heart rate monitor by pressing any button. If the

heart rate monitor has not received any signal for approx. five minutes, it

switches to the power saving mode. At that point, only the current time

and the date will be displayed. Press any button in order to reactivate

the watch.

Putting on the chest strap

 Tighten the chest strap with the elastic tension

belt. Adjust the length of the belt such that the belt

is snug, but neither too loose nor too tight. Position

the belt around the chest such that the logo is fac-

ing outwards and in the correct position directly

over the breast bone. For men, the chest belt

should be located directly below the pectoral mus-

cles, for women, directly below the breast.

 Since optimal contact between the skin and the heart rate sensors

can not be created immediately, it may take some time until the heart

rate is measured and displayed. If necessary, alter the position of the

transmitter in order to achieve optimal contact. Most of the time, suf-

ficient contact is achieved through the accumulation of sweat be-

neath the chest strap. You can, however, also wet the contact points

on the inside of the chest strap. For this, lift the chest strap up from

the skin slightly and wet the two sensors with saliva, water or ECG

gel (available at the chemistry). The contact between the skin and

chest strap may not be interrupted also with greater movements of

the thorax such as during deep breathing. Significant chest chair can

interfere with and even prevent contact.

 Put on the chest strap a few minutes before starting in order to warm

it up to body temperature and establish optimal contact.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 87 88

No comments

Beurer PM 62 Operations Instructions Page 12