Beurer JBY 101 Service Manual download pdf (Page 16)

13 What if there are problems?

Faults Actions

Power LED does not light up

after switch-on

Check whether

š the relevant power supply unit is correctly connected.

š the batteries are full or the rechargeable battery needs charging or

is damaged.

On the monitor, an acoustic sig-

nal sounds and “out of range”

appears

Check whether

š the maximum range has been exceeded.

š the power supply unit for the camera is correctly connected.

š the camera is switched on.

š the batteries are full or the rechargeable battery needs charging or

is damaged.

The signal is weak, the connec-

tion keeps breaking up or there

is interference

š If another technical device such as a microwave is in the area

between the camera and the monitor, remove the device, or switch

it o.

š Check whether other factors, such as trees or anything else are

in the area between the devices, and change the position of the

devices until the monitor signals a connection.

š Check whether the camera and monitor are inside the maximum

receiving range.

Tuning the device signals.

If no transmission is possible

and only “OUT OF RANGE” is

shown, you have the option to

retune the device signals digit-

ally = pairing.

Position the monitor and camera 30 cm apart.

1. Turn on both units

2. Press and hold the “VOX” button on the monitor and night vision

button on the camera for 3 - 5 seconds.

3. The monitor displays “SINGAL SEARCHING” and the power LEDs

on the monitor and the night vision ﬂash 3 times. Then release the

buttons.

4. Switch o camera and monitor.

5. When the camera and monitor are switched on again, the LINK LED

should glow green and a clear tone and good picture are transmitted.

On the monitor, there is no

acoustic signal

š Adjust the volume on the receiving device (monitor).

Camera or monitor switches

itself o

š Change the batteries or recharge the battery.

š If the operating display lights up, but only a noise signal is regis-

tered, the monitor could be in ECO mode. Press the

ECO

button to

switch on the screen.

We hereby guarantee that this product complies with the European R&TTE Directive 1999/5/EC.

Please contact the speciﬁed service address to obtain further information, such as the CE Declaration of

Conformity.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Comments to this Manuals

No comments

Beurer JBY 101 Service Manual Page 16

Comments to this Manuals