Beurer PM 80 Operations Instructions download pdf (Page 13)

Activating the HR watch from transport mode

During transport the monitor is blank. You can remove the transport

mode by pressing the button

and then

START/STOP

Activating the heart rate monitor from power saving

mode

You can activate your heart rate monitor by pressing any key. If the

heart rate monitor has not received any signal for approx. five min-

utes, it switches to the power saving mode. At that point, only the

current time and the date will be displayed. Press any key in order to

reactivate the watch.

Putting on the chest strap

 Tighten the chest strap with the elastic tension

belt. Adjust the length of the belt such that the

belt is snug, but neither too loose nor too tight.

Position the belt around the chest such that the

logo is facing outwards and in the correct posi-

tion directly over the breast bone. For men, the

chest belt should be located directly below the

pectoral muscles, for women, directly below the

breast.

 Since optimal contact between the skin and the heart rate sensors

can not be created immediately, it may take some time until the

heart rate is measured and displayed. If necessary, alter the posi-

tion of the transmitter in order to achieve optimal contact. Most of

the time, sufficient contact is achieved through the accumulation

of sweat beneath the chest strap. You can, however, also wet the

contact points on the inside of the chest strap. For this, lift the

chest strap up from the skin slightly and wet the two sensors with

saliva, water or ECG gel (available at the chemistry). The contact

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 123 124

No comments

Beurer PM 80 Operations Instructions Page 13