Beurer PM15 Instruction for Use download pdf (Page 25)

•Whentheword„Beep“appearsinthedisplay,youcanchoosewhethertohavetheconrmationtone

(the „beep“) on or off using the Start/Stop or Reset buttons. If the conﬁrmation tone is activated, a

short beep sounds every time a button is pressed.

•Oncealldatahasbeenset,holdtheMODEbuttondownfor3secondstoexitsettingmode.

•Ifnobuttonsarepressedinsettingmodewithin60seconds,theheartratemonitorautomatically

reverts to time display.

8. Heart rate measurement

•Fastenthemonitortoyourwrist.

•Placeonengeronthesensorandholditdownforatleast5seconds.Makesurethatthe

sensor at the back of the casing ﬁts closely to the skin. At ﬁrst, the display reads „---“.

•After5to8seconds,theheartratereadingisdisplayed.

•Iftheheartratealarmisswitchedon,therelativeheartrateisalsodisplayed.

•Ifthemeasuredheartrateisbelowthelowerheartratelimit,thisisindicatedbyan„L“.Anyvalue

above the upper heart rate limit is indicated by an „H“.

•If,inpulsealarmmode,pulselimitsaccordingtoageandgenderhavealsonotchanged,themeasured

heart rate in the ﬁtness performance range (between 65% and 85% of the maximum heart rate) is

displayed graphically.

•5secondsafterreleasingthebutton,theheartratemonitorreturnstothepreviousmode.

Advice and tips

1. Heart rate measurement is possible in any function mode.

2. One sensor is ﬁtted on the back of the monitor casing. The sensor has to have constant, ﬁrm contact

with the skin.

3. Never measure heart rate under water.

date display

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 119 120

No comments

Beurer PM15 Instruction for Use Page 25