Beurer PM 58 Operations Instructions download pdf (Page 35)

Once you are in the menu

Training, your HR

monitor automatically switches to the main dis-

play. This displays the already recorded training

time on the middle line (after Save/Delete:

00:00:00) and on the line below

Start.

By pressing the

button you can change

the information in the bottom line.

Things to know about the recordings

 As soon as you have started the recording, your HR monitor

starts recording your training data. Your HR monitor continually

records your training data until you save or delete this. This also

applies when you first start training on the following day. The run-

ning time also allows you to stop your training session at any

time.

 If “0” is displayed for a longer period on the display, this means

that the receipt of the signals has been interrupted. In this case

change into the

Training menu, by pressing

8 times.

The HR monitor tries to make contact with the devices once more.

 Your HR watch has a memory. You can record up to 23:59:59

hours in each training session. Depending on the sampling rate,

you can record training periods ranging from 2.8 hours (with a

5 sec interval) to 67 hours (with a 120 sec interval). Once

23:59:59 hours is reached, you must either save or delete the

training session to allow a new training session to start. A maxi-

mum of 50 laps is possible for each training. Your HR monitor

informs you if the

memory is almost full. At this point, at the la-

test, we recommend transmitting the recordings to your PC and

thus emptying the memory on the HR watch. Alternatively you can

delete all recordings manually. Read the section “Delete all

recordings” in this chapter to find out how to delete the recordings.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 143 144

No comments

Beurer PM 58 Operations Instructions Page 35