Beurer BC 80 User Manual download pdf (Page 20)

100

•

Close the cuff with the hook-and-loop fastener such that the

upper edge of the device is positioned approx. 1 cm under-

neath the heel of the hand.

•

The cuff must be fitted tightly around the wrist, but must not

constrict.

Adopt the correct posture

•

Before every measurement, relax for about five minutes. Oth-

erwise deviations can occur.

•

You can take the measurement

while sitting or lying. To take

your blood pressure, make sure

you are sitting comfortably with

your arms and back leaning on

something. Do not cross your

legs. Place your feet flat on the

ground. Make sure to rest your arm and move it. Always

make sure that the cuff is at heart level. Otherwise

significant deviations can occur. Relax your arm and the

palm of your hand. An O.K. symbol bar is integrated into

the device to additionally assist you. It signals the correct

position of the blood pressure monitor. You are in the right

position if you can see O.K. on the display.

•

To avoid falsifying the measurement, it is important to remain

still during the measurement and not to speak.

Performing the blood pressure measurement

As described above, attach the cuff and adopt the posture in

which you want to perform the measurement.

•

Press the START/STOP button to

start the blood pressure monitor. All

displays will illuminate briefly.

The blood pressure monitor will begin the

measurement automatically after 3 sec-

onds.

The measurement is taken during the in-

flation phase.

You can cancel the measurement at any time by pressing

the START/STOP button

As soon as a pulse is found, the pulse symbol is displayed.

•

The systolic pressure, diastolic pressure

and pulse rate measurements are

displayed.

•

_ appears if the measurement could not be performed prop-

erly. Observe the chapter on error messages/

troubleshooting in these instructions for use and

repeat the measurement.

•

Now select the desired user memory by pressing

the M1 or M2 memory buttons. If you do not select a user

memory, the measurement is stored in the most recently used

user memory. The relevant symbol M1 or M2 appears in the

display.

•

Press the START/STOP button to switch off the blood

pressure monitor. The measurement is then stored in the

selected user memory.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Comments to this Manuals

No comments

Beurer BC 80 User Manual Page 20

Comments to this Manuals

Related products and manuals for Health and hygiene Beurer BC 80