Beurer BY 33 User Manual download pdf (Page 21)

6. Initial use

Baby unit

Operation with mains part

Position the baby unit so that it is in an elevated position and is not in proxi-

mity to any other devices that may cause interference.

Using the mains part plug, connect the baby unit to a socket.

The device automatically switches on.

The power LED will light up green.

To switch the device o press the ON/OFF button for at least 2 seconds or

unplug the mains part. The power LED will go out.

To switch the device on again press the ON/OFF button for approx. 2 seconds.

Parent unit

Set up the parent unit in the room where you are going to be.

Battery operation – charging

To ensure optimal safety, the parent unit is designed so that it can

only be operated with batteries inserted.

The battery must be charged for at least 16 hours before the device can be

ﬁrst used independently of the mains; you may use the device during this

period.

Switch the parent unit on by pressing the button for 2 seconds. The power

LED of the parent unit will light up green. The device is active.

If the parent unit battery is low the unit will beep twice. If the device is not

connected to a socket, it will switch o automatically after a short period. The

power LED will go out.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 103 104

No comments

Beurer BY 33 User Manual Page 21