Beurer IPL 7000 User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 124
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
36
Treating the neck and chin
Position the light area of the device as shown in the figure. At each point,
trigger a pulse and move from one side of the neck or chin to the other.
Care after facial treatment
•
Apply a soothing lotion such as aloe vera.
•
Do not use exfoliators, whitening lotions or similar products for at least
24hours, as this could irritate the treated skin.
•
For at least 48 hours after the treatment, avoid more than 15 minutes of direct exposure
to the sun. If the treated skin is exposed to sunlight during this period, sun protection with
SPF30 or higher must be applied.
•
Do not remove hair on the treated areas using wax or tweezers.
Remember that it may take a complete hair growth cycle for hair removal to be
complete.
6.3 Application cycle
For body treatment:
•
The first three or four hair removal sessions using the beurer SalonPro System should be
performed around two weeks apart.
•
The fifth to seventh hair removal sessions using the beurer SalonPro System should be
performed around four weeks apart. Afterwards, you may use the beurer SalonPro System
from time to time as necessary, until lasting results are achieved.
For facial treatment:
•
The first six hair removal sessions using the beurer SalonPro System should be performed
around two weeks apart.
•
The seventh to twelfth hair removal sessions using the beurer SalonPro System should be
performed around four weeks apart. Afterwards, you may use the beurer SalonPro System
from time to time as necessary, until lasting results are achieved.
This corresponds to the recommended treatment plan that has proven to achieve the best
results. You can, however, create a dierent personal treatment plan and still achieve sat-
isfactory results.
6.4 After treatment using the device
1. When you have completed the hair removal session, hold and press the ON/OFF/power
selection button for 3 seconds. The device is in stand-by mode when the the small, green
indicator lamp flashes.
2. Remove the mains adapter from the mains socket.
3.
After each hair removal session, it is recommended that you clean the device, in particular
the light area (see “Maintenance and cleaning”).
4. After cleaning, it is recommended that you store the device in its original box and keep
it away from water.
5.
After treatments, do not use any antiperspirants/deodorants as these may cause skin
irritation.
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 123 124

Comments to this Manuals

No comments