Beurer GL 42 (mg/dL) User Manual download pdf (Page 14)

14 Beurer GL42 mg/dL

initial use and basic settinGs

4.1 Removing the battery insulation strips, replacing the battery

Note

•

Remove the insulation strip before initial use.

Remove the battery compartment lid on the underside of the device.

If you are replacing the battery, reset the date and time as required (“Making and changing

basic settings” on page 14).

Insert a new battery of type CR 2032 3 V. Make sure that the battery is inserted with the correct

polarity, according to the label. See the graphic in the battery compartment.

Close the battery compartment lid again carefully.

Note

•

The batteries are almost empty if the replace battery symbol appears. Replace the battery as

soon as possible.

•

If “ ” appears on the display, the battery power level is so low that no more measurements can be

taken.

4.2 Making and changing basic settings

Remove the battery and then reinsert it. Alternatively, press the “+” button

[2] and the On/O button for a minimum of ﬁve seconds.

An acoustic signal sounds.

The year display ﬂashes.

Setting the date and time

Note

•

You must set the date and time. Otherwise, you will not be able to save your measured values

correctly with a date and time to retrieve them later.

•

The time is displayed in the 24-hour format.

Set the year (calendar to 2099) by pressing the “+” or “–” [2] button. Conﬁrm by pressing the

On/O button [5].

The day display ﬂashes.

Proceed as described above for the month, day, hour and minute.

CR 2032 H

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Beurer GL 42 (mg/dL) User Manual Page 14