Beurer GL 50 evo (mgdl) User Manual download pdf (Page 23)

Beurer GL50 evo mg/dL 23

5.4 Reading the result and labelling measurements

Read the result

As soon as the blood input gap is ﬁlled with sucient

blood, the device performs the blood glucose measure-

ment. The blood glucose monitor counts down for ap-

prox. ﬁve seconds. The measured result is then shown

on the display.

Read your measured value. Check again that you have read the result correctly. The underline must be

below the measured value, otherwise you need to turn the monitor by 180°. For explanations of and

measures regarding the measured values, see “5.6 Evaluating measured blood glucose values” on

page 23. If an error message is displayed, read chapter “8. What if there are problems?” on page 33.

Label measured value

You have the following options for labelling measured values.

Before a meal

After a meal

General label (e.g. after exercising)

Labelling measured values enables you, your GP or diabetes consultant to better monitor your blood

glucose values. For example, you can display the average values of all measurements taken before

a meal.

To label a measurement, proceed as follows:

Following the measurement, the display will brieﬂy show the measured value and then the

menu in which you can mark the measured value. It is not possible to mark the measured

value afterwards.

Select the desired marking using the scroll wheel.

No marking

Before a meal

After a meal

General label

Conﬁrm the marking by pressing the scroll wheel.

The selected marking is now allocated to the measured value and saved to the memory.

The selected label is stored in the memory of the device when it is switched o.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Beurer GL 50 evo (mgdl) User Manual Page 23