Beurer GL 50 evo (mgdl) User Manual download pdf (Page 29)

Beurer GL50 evo mg/dL 29

6 measurement memory

For each measurement, your blood glucose value is automatically saved with the date and time unless

“CONTROL” was activated for a blood glucose measurement using control solution.

The memory can store a maximum of 480 measured values. If the memory is full, the oldest value is

replaced by the most recent value. You can call up every individual measured blood glucose value.

You can also calculate and display the average value for the last 7, 14, 30 and 90 days.

Note

•

If you have already saved measured values and you reset the date, the average values are calculated

as from the new period.

•

“No saved values” indicates an empty memory for measured values. Press the scroll wheel button

to switch o the device.

6.1 Displaying individual values

The most recent measured value is displayed ﬁrst, and the oldest last. The date and time are also

displayed on the monitor at the same time.

Switch on the blood glucose monitor by brieﬂy pressing and holding the scroll wheel.

Rotate the scroll wheel until the arrow is pointing towards “All values”, then press the scroll

wheel to conﬁrm.

You can now rotate the scroll wheel to navigate between the saved individual values.

You can cancel the process at any time. To do so long, press the scroll wheel or wait until

the device switches itself o automatically after two minutes.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

No comments

Beurer GL 50 evo (mgdl) User Manual Page 29