Beurer MPE 70 User Manual download pdf (Page 14)

•Insertthemainsplugintothesocket(220-240V,~50/60Hz).

The green operation light on the paraffin bath will light up.

Thedeviceisnowswitchedon.Theredheatinglightonthe

paraffin bath will also light up, and will only go out when the

specified heat setting has been reached.

•Turnthetemperaturecontrollerto“hot”tomelttheparaffin

wax.

•Nowplacethelidontheparaffinbathandwaituntilthe

paraffin wax has completely melted (around 2-3 hours).

Warning

Iftheparaffinbathissetto“hot”,neverdipyourhands,feetor

elbows in the paraffin wax.

•Assoonastheparaffinwaxhascompletelymelted,remove

the lid.

•Turnthetemperaturecontrollertothemarkedlinebetween

“warm”and“hot”.

•Laytheprotectivegrilleincludedinthedeliverycontentsinthe

liquid paraffin wax and wait until it has sunk to the bottom of

the paraffin bath.

•Putthelidbackontotheparaffinbathandwaitapproximately

one hour, until the paraffin wax has cooled to an ideal

operating temperature (60°C).

Warning

Theroomtemperaturecanaffectthepowerofthedeviceand

consequently the temperature of the wax.

Before submerging your hands, feet or elbows in the paraffin

bath, use the inside of your wrist to check that the temperature

of the wax is comfortable.

If a skin should form on the wax surface, increase the

temperature by turning the temperature controller clockwise. If

the paraffin wax is too hot for you, reduce the temperature by

turning the temperature controller anti-clockwise.

7. Operation

Warning

Before submerging your hands, feet or elbows in the paraffin bath, use the inside of your wrist to

check that the temperature of the wax is comfortable.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 83 84

No comments

Beurer MPE 70 User Manual Page 14