Beurer GL 50 (mg/dL) User Manual download pdf (Page 32)

32 Beurer GL50 mg/dL

Evaluating measured values on the PC

The blood glucose monitor must be switched o.

Insert the monitor’s USB connector into a free USB

port on your PC. In the event that the measuring

device is not recognised, please try using another

active USB point.

“ ” is shown on the display of the blood glucose

monitor. Saved data can now be viewed on your PC.

See the information on evaluating values in the software manual.

7 storinG, maintaininG and disinfectinG the device

Storing

Keep the Beurer GL50 blood glucose monitor in the case supplied after each measurement

and do

not expose it to direct sunlight

Note

•

Do not store the device, test strips and control solution in your vehicle, in the bathroom or in a cool-

ing appliance.

•

Retain these Instructions for use.

•

Remove the batteries if you do not intend to use the device for a prolonged period of time.

•

Only clean the device when it is switched o.

7.1 Maintenance

Clean the surface of the device using a soft, slightly damp cloth (water or a mild cleaning solution).

Dry the device using a lint-free cloth.

Make sure that moisture does not enter the test strip insertion slot. Do not spray cleaning agent di-

rectly on the device. Do not submerge the device in water or any other ﬂuids and make sure that no

ﬂuids can enter the device.

7.2 Disinfection

Please comply with the generally applicable guidelines on disinfection when using the device on dif-

ferent persons. Do not submerge the device in disinfection solutions or any other ﬂuids and make

sure that no ﬂuids can enter the device.

The cap on the integrated lancing device can be disinfected with 70 – 75% alcohol. Disinfect the

cap at least once a week and submerge the cap in alcohol for approx. 10 minutes. Allow the cap

to air dry.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Beurer GL 50 (mg/dL) User Manual Page 32