Beurer GL50 Specifications download pdf (Page 28)

28 Beurer GL50 mg/dL

6 measurement memory

For each measurement, your blood glucose value is automatically saved with the date and time un-

less “ ” was activated for a blood glucose measurement using control solution.

The memory can store a maximum of 480 measured values. If the memory is full, the oldest value is

replaced by the most recent value. You can call up every individual measured blood glucose value.

You can also calculate and display the average value for the last 7, 14, 30 and 90 days.

Note

•

If you have already saved measured values and you reset the date, the average values are calculated

as from the new period.

•

“---” indicates an empty memory for measured values. Press the ON/OFF button to switch o the

device.

6.1 Displaying individual values

The individual values from the last 480 measurements are displayed. The most recent measured

value is displayed ﬁrst, and the oldest last. The date and time are also displayed on the monitor at

the same time.

Switch the monitor on using the on/o button [1]. The initial display is shown brieﬂy. Press

the “+” or “–” rocker switch [3].

“

Mem

” and the number of saved blood glucose tests are displayed brieﬂy (Image 1). The

display then changes to the most recent saved value including the measurement unit, date,

time, “

Mem

” and any label (Image 2).

Image 1 Image 2

Each time you press the rocker switch “–” again, ﬁrst the memory space number will be

displayed and then the relevant measured value. You can display a maximum of 480 pre-

vious measurements.

You can cancel the process at any time. To do so, press the ON/OFF button or wait until

the device switches itself o automatically after two minutes.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Beurer GL50 Specifications Page 28