Beurer GL 40 (mg/dL) User Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
22 Beurer GL40 mg/dL
Results to be expected
At room temperature, the measurement results for 95% of all control solution tests should lie within
the results range printed on the test strip container.
Warning
The result range printed on the test strip box applies only to the control solution. This is not a rec-
ommended value for your blood glucose content.
If measured values are outside the specified range, check the following possible causes:
Cause Action
The first drop of control solution was not dis-
posed of.
The tip of the bottle was not wiped clean.
The bottle was not shaken vigourously enough.
Eliminate the cause and repeat the test.
The control solution or the test strip has expired
or is contaminated.
Repeat the test using a new bottle of control
solution / a new test strip.
The control solution, test strip or measuring
device is too warm or too cold.
Allow the measuring device, test strips and
control solution to reach room temperature
(+20°Cto+25°C)andrepeatthetest.
Test strip is damaged.
Repeat the test using a new test strip
Test strip is out of date. Open a new container of test strips.
Repeat the test.
There is a problem with the measuring
device.
Please contact customer service.
Warning
If you repeatedly obtain measurement results with the control solution which are outside of the
specified range, refrain from using the system to determine your blood glucose content. Please
contact customer service.
6 MeAsureMent MeMorY
For each measurement, your blood glucose value is automatically saved with the date and time un-
less “ ” was activated for a blood glucose measurement using control solution.
The memory can store a maximum of 480 measured values. If the memory is full, the oldest value is
replaced by the most recent value. You can call up every individual measured blood glucose value.
You can also calculate and display the average value for the last 7, 14, 30 and 90 days.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments