Beurer GL 42 (mg/dL) User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
Beurer GL42 mg/dL 9
Very high levels of humidity may influence the test results. Relative humidity of more than 90% may
lead to inexact results.
Note
The Beurer GL42 mg/dL measuring system is intended for measuring capillary and venous whole
blood.
Storage and maintenance
Warning
•
Store the blood glucose monitor and its accessories out of reach of small children and pets. Small
parts, such as lancet needles, parts of the lancing device, batteries or test strips may be life-threat-
ening when swallowed. If swallowed, seek medical attention immediately.
•
The test strip box contains desiccant, which may irritate the skin or eyes when inhaled or swallowed.
Keep the box out of the reach of children.
The blood glucose monitor is made from precision and electronic components. The accuracy of the
measurements and service life of the device depend on its careful handling:
Protect the device and its accessories from impacts, humidity, dirt, marked temperature fluctua-
tions and direct sunlight. Do not store the device, test strips and control solution in your vehicle, in
the bathroom or in a cooling appliance!
Do not drop the device.
Batteries / Saving measured values
Warning
•
Keep batteries out of the reach of children. Children could put batteries in their mouth and swallow
them. This may severely damage their health. In such cases, seek medical assistance immediately!
•
Normal batteries must not be charged, heated or thrown into an open fire (risk of explosion!).
Important
Batteries must not be taken apart or short circuited.
Leaking batteries may damage the device. If you do not intend to use the device for longer periods,
remove the batteries from the battery compartment.
Attention!
•
Leaking or damaged batteries may burn the skin, therefore use suitable protective gloves if this is
the case.
Note
•
The stored blood glucose values are retained when the batteries are replaced. If applicable, the date
and time must be reset after replacing the batteries.
Use lithium-ion batteries only.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments