Beurer EM 38 User Manual download pdf (Page 15)

Item Item Designation Item Item Designation

1 On/o/pause button 6 Battery status, appears when batteries are used up

2 Intensity adjustment

increase

decrease

7 Intensity, level 0 – 20

8 Pause symbol, ﬂashes when activated

3 Program/locking key 9 TIMER: Remaining time of the active programs in

minutes

4 Battery compartment 10 Keylock active

5 Display with LCD display 11 Active program

5. Using the unit for the ﬁrst time and changing the batteries

Putting on the belt

Before each use, ensure that your skin is clean and free of creams or oils.

Only in this way the unit can work optimally.

•

Lay out the belt before you with the electrodes facing you.

•

Moisten the electrodes and your back with water. Ensure that the elec-

trode surfaces are moistened evenly to avoid localised voltage peaks

when they are applied to your skin.

•

Fit the belt around your waist so that the vertical seams A are at the

same place on each side of your body. The Beurer logo B is then in the

middle of the spinal column.

See the diagram.

When positioned correctly, the electrodes C are slightly to the left and right of your spinal column.

• Then, close the Velcro fastener.

Ensure that the belt ﬁts tightly enough to provide a good contact between the electrodes and your skin, but

does not constrict.

Extending the belt

If the belt is not adequate for your waistline, you can use the extension belt provided. Depending on your

waistline, the holder for the control unit may be away from the centre of your body. It is important that the

belt is positioned correctly, therefore the electrodes C must be to the left and right of the spinal column.

Inserting the control unit

•

Insert the control unit into the holder on the belt.

•

The operating keys should be facing outwards and the display should be

facing upwards and towards you.

•

If inserted correctly, the control unit clicks into the holder.

Automatic shuto

If the unit is not used after being switched on, it switches o automatically

after 3 minutes.

Changing the batteries

If the battery status indicator [6] ﬂashes, it is time to change the

batteries. To insert or replace batteries,

you have to remove the control unit from the holder of the belt.

•

Release the magnetic connection by gently pulling the control unit

away from the belt. You can feel the magnetic connection of the two

contact buttons unsnap.

•

Pull the unit upwards and out of the holder.

•

Open the battery compartment [4] by pushing the cover downwards

at the arrow mark.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 73 74

Comments to this Manuals

No comments

Beurer EM 38 User Manual Page 15

Comments to this Manuals

Related products and manuals for Health and hygiene Beurer EM 38