Beurer BM 65 User Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 116
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
23
Correct posture
Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
You can perform the measurement either sitting or lying
down. Always make sure that the cuff is on a level with
your heart.
To carry out a blood pressure measurement, make sure
you are sitting comfortably with your arms and back lean-
ing on something. Do not cross your legs. Place your feet
flat on the ground.
In order not to distort the result, it is important to keep still
during the measurement and not talk.
Measuring blood pressure
Put on the cuff as described previously and assume the
position in which you want to carry out the measurement.
Switch on the blood pressure monitor with the START/
STOP button . After the full-screen display, the most
recently used user memory appears ( U0, U1....U9 ). To
change the user memory, press the MEM button and
confirm your selection with the START/STOP button .
If no button is pressed, the most recently used user
memory is automatically used after 5 seconds.
Before the measurement, the last saved test result is
briefly displayed. If there is no measurement in the memo-
ry, the instrument always displays the value
.
The cuff automatically inflates. Cuff air pressure is re-
leased slowly. If a tendency towards high blood pressure
is already detectable, the cuff is pumped up again and
cuff pressure increased further. As soon as a heart rate is
detected, the heart beat symbol is displayed.
Heart rate, systolic and diastolic blood pressure are dis-
played.
Measuring can be cancelled at any time by pressing the
START/STOP button
.
appears if it has not been possible to perform the
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
The test result is saved automatically.
To switch off, press the START/STOP button . If you
forget to turn off the device, it will switch off automatically
after approx. 1 minute.
Wait at least 5 minutes before taking another measurement!
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 115 116

Comments to this Manuals

No comments