Beurer BM 75 User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 128
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
28
Individual measured values
When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
When the relevant memory button (M1 or M2) is
pressed again, you can view your individual measure-
ments.
To switch the device off again, press the Start/stop
button or wait 30 sec.
You can exit the menu at any time by pressing the
Start/stop button .
Deleting measured values
To clear the memory of the relevant user memory, you
must first select a user memory.
Start individual measurement access.
Press and hold the M1/M2 memory buttons for 5 sec-
onds.
All the values in the current user memory are
deleted.
8. Transferring measurements
USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
PC
is shown on the display. Begin the data transfer
in the “HealthManager” PC software. During the
data transfer, an animation is shown on the display.
A successful data transfer is displayed as in
figure 1. If the data transfer is unsuccessful, an
error message appears as in figure 2. In this case,
interrupt the PC connection and start the data
transfer again.
After 30 seconds of not being in use or if commu-
nication with the PC is interrupted, the blood pres-
sure monitor switches itself off automatically.
NFC
It is also possible to transfer the measured values saved on the
device onto your smartphone via NFC (Near Field Communi-
cation).
You will need the “Beurer HealthManager” app for this. The
app can be installed from the Play Store.
To transfer the values, unlock your smartphone screen and
hold the back of your phone up to the NFC detection zone of
the blood pressure monitor. If your smartphone has a protec-
tive cover, remove this to ensure that there is no interference
during the transfer. Begin the data transfer in the “Beurer
HealthManager” app.
f
igure 1
f
igure 2
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 127 128

Comments to this Manuals

No comments