Beurer BM 47 User Manual download pdf (Page 24)

š pumping up takes longer than 160 seconds (

appears

on the display)

š there is a system or device error (

, , or

appears on the display)

š the batteries are almost empty

In such cases, repeat the measurement. Ensure that you do

not move or speak.

If necessary, reinsert or replace the batteries.

Technical alarm – description

Should the recorded blood pressure (systolic or diastolic) lie

outside the limits specified in the section “Technical speci-

fications”, the technical alarm will appear on the display

indicating either “

” or “Lo”. In such cases, you should seek

medical assistance and check the accuracy of your proce-

dure.

The limit values for the technical alarm are factory set and

cannot be adjusted or deactivated. These alarm limit val-

ues are accorded second priority under the standard IEC

60601-1-8.

The technical alarm is a non-locking alarm and must not be

reset. The signal shown on the display will disappear auto-

matically after about 8 seconds.

9. Cleaning and storing the unit

Clean your blood pressure device carefully with a slightly

damp cloth only.

Do not use any cleaning agents or solvents.

Under no circumstances should you hold the unit under

water, as this can cause liquid to enter and damage the

unit.

If you store the unit, no heavy objects should be placed

on top of it. Remove the batteries. The cuff line should not

be bent sharply.

10. Technical specifications

Model no. BM 47

Measurement

method

Oscillometric, non-invasive blood

pressure measurement on the upper

arm

Measurement range Cuff pressure 0-300 mmHg,

systolic 60-260 mmHg,

diastolic 40-199 mmHg,

Pulse 40-180 beats/minute

Display accuracy Systolic ± 3 mmHg,

diastolic ± 3 mmHg,

pulse ± 5 % of the value shown

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 103 104

Comments to this Manuals

No comments

Beurer BM 47 User Manual Page 24

Comments to this Manuals

Related products and manuals for Health and hygiene Beurer BM 47