Beurer FW 20 User Manual download pdf (Page 11)

4.2 Initial use

Insert the mains plug into the socket.

4.3 Switching on

To switch the foot warmer on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.

The temperature settings (4) are illuminated when switched on.

4.4 Setting the temperature

Level 0: OFF

Level 1: minimum heat

Level 2: medium heat

Level 3: maximum heat

NOTE:

The fastest way to warm up the foot warmer is to initially set the highest temperature setting.

NOTE:

This foot warmer has a fast heating function, which allows the foot warmer to warm up

faster in the first 10 minutes.

WARNING

If the foot warmer is being used over several hours, we recommend that

you set the lowest temperature setting on the controller to avoid over-

heating the feet, which may lead to burns to the skin.

4.5 Automatic switch-off

This foot warmer is equipped with an automatic switch-off function. This turns off the heat sup-

ply approx. 90 minutes after the initial use of the foot warmer. The temperature setting display

then starts to flash. So that the foot warmer can be switched back on, the sliding switch for ON/

OFF and temperature settings (5) must first be set to setting “0” (OFF). After about 5 seconds

it is possible to switch it on again.

4.6 Switching off

To switch the foot warmer off, set the sliding switch for ON/OFF and temperature settings to setting “0” (OFF).

The temperature settings are then no longer illuminated.

NOTE:

If the foot warmer is not in use, switch the sliding switch for ON/OFF and temperature settings to

setting “0” (OFF) and unplug the mains plug from the socket.

5. Cleaning and maintenance

WARNING

Before cleaning, always remove the mains plug from the socket first.

Otherwise there is a risk of electric shock.

90 min

STOP

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

No comments

Beurer FW 20 User Manual Page 11