Beurer HK 65 Aroma User Manual download pdf (Page 11)

5. Appliance description

1 Heating pad

2 Plug-in coupling

3 Cover

4 Switch

5 Herb insert

6. Initial use

Remove the packaging from the desired herb insert and smooth it out onto the heating pad

through the opened heating pad cover. Then close the zip fastening. Then check if the switch

is connected to the heating pad via the plug-in coupling. Insert the mains plug into the socket.

Place the heating pad on the upper body to enable the essential vapours to be inhaled.

7. Operation

7.1 Safety

This heating pad has a SAFETY SYSTEM. This electronic sensor technology prevents the enti-

re surface of the heating pad from overheating by automatically switching off in the event of a

fault. If the safety system switches off the heating pad automatically as a result of a fault, the

indicator lamp is no longer illuminated even when the heating pad is switched on. Please note

that, after a fault has occurred, the heating pad can no longer be used for safety reasons and

must be sent to the service address indicated.

7.2 Selecting temperature

After switching on, the switch position will remain continuously illuminated. The fastest way to

heat up the heating pad is to rst set the switch to the highest setting. A lower setting can be

selected later if required.

We recommend the lowest temperature setting for extended use of the heating pad.

7.3 Temperature settings

Setting: 0 Off

1 Minimum heat

2 Medium heat

3 Maximum heat

7.4 Automatic switch-off function

This heating pad is equipped with an automatic switch-off function. This turns off

the heat supply approx. 90 minutes after the initial use. The switch position will

then begin to ash. In order to reactivate the heating pad, the position switch must

initially be set to the "0" position. After about 5 seconds it is possible to switch it

on again.

90min

STOP

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Beurer HK 65 Aroma User Manual Page 11